First thing I corrected was the Z steps per mm, but the even bigger difference came when I corrected the extruder's steps per mm again.
Here are the results:
Highly Calibrated
The Reprap IRC told me how to make "on the fly" changes to the calibration of my printer. This only works on Marlin Firmware for Reprap electronics though. An example of the process (if you wanted to change your steps per mm for the z axis to 2560): type M92 Z2560 in the pronterface console, M500 to save the changes, then M501 to view the changes. Now there's no longer any need to recompile the firmware just to tweak the calibration.
First thing I corrected was the Z steps per mm, but the even bigger difference came when I corrected the extruder's steps per mm again.
Here are the results:
First thing I corrected was the Z steps per mm, but the even bigger difference came when I corrected the extruder's steps per mm again.
Here are the results:
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment